Hardware Identification Chart - Smooth Fitness SMB-XBIKE Owner's Manual

"H
I
ARDWARE
Unpack the box in a clear area. Review the Hardware Kit List below. This chart is provided to help identify the hardware
used in the assembly process. Place the washers, the ends of the bolts, or screws on the circles to check for the correct
diameter. Use the small ruler to check the length of the bolts and screws. Do not dispose of the packing material until the
trial period has expired
NOTICE: The length of all bolts and screws, except those with flat heads, are
measured from below the head to the end of the bolt or screw. Flat head
bolts and screws are measured from the top of the head to the end of the
bolt or screw
Note: The assembly hardware has been pre-assembled.
Please review the contents of the hardware kit pictured below.
The hardware and some small parts may have been pre-attached for shipping. If a part is not in the hardware bag, check to
see if it has been pre-assembled. You can refer to the exploded diagram on page 16 for hardware placement
HARDWARE
DENTIFICATION
Part No. and Description
#4 Bolt (M6 X 12mm)
#10 Carriage bolt (M8x50mm)
#18 Bolt(M8X45mm)
#15 Screw(M5x15mm)
#6 Flat washer (M6)
#22 Flat washer (M8)
#5 Curved washer (M6)
#9 Curved washer (M8)
#19 M8 Spring washer
#12 Cap nut (M8)
#16 Nylock nut (M8)
C
HART"
5
Q'TY
4pcs
6pcs
4pcs
2pcs
2pcs
7pcs
2pcs
4pcs
6pcs
4pcs
5pcs