Log Placement; Charcoal & Glowing Embers - Napoleon BGNV42N Installation And Operation Instructions Manual

LOG PLACEMENT

PHAZER TM logs and glowing embers, exclusive to Napo-
leon Fireplaces, provide a unique and realistic glowing ef-
fect that is different in every installation. Take the time to
carefully position the glowing embers for a maximum glow-
ing effect. Log colours may vary. During the initial use of the
fireplace, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
FIGURES 19a-e
1. Place the back log (#1) onto the log support tray and in
front of the tabs. The tabs maintain an air space between
the log and firebox back to facilitate combustion air flow.
Ensure that the back of the log rests against the brackets
on the back wall of the firebox.
#2
2. Move the two small logs (#2 & #3) into position, lining
up the studs located on the burner with the holes on the
bottom of the logs.
GLOWING EMBERS
3. Tear the glowing embers into pieces and place along
the front row of ports covering all of the burner area in front of
the small logs (#2 & #3). Care should be taken to shred the
embers into thin, small irregular pieces as only the exposed
edges of the fibre hairs will glow. The ember material will
only glow when exposed to direct flame; however, care should
be taken to not block the burner ports. Blocked burner ports
can cause an incorrect flame pattern, carbon deposits and
delayed ignition. PHAZER
direct flame.
#1
#3
TM logs glow when exposed to
#4
4. Place the bottom of the left crossover log (#4) against
the left outermost grate post and the top into the pocket
provided on the back log. Position the notch located on the
end of the center log (#5) against the middle grate post
with the other end of the log resting in the pocket of the left
crossover log.
5. Place the bottom of the right crossover log (#6) against
the right outermost grate post and the top into the pocket
provided on the center log (#5).
CHARCOAL EMBERS
Randomly place the charcoal embers along the front and
sides of the log support tray in a realistic manner. Fine
dust found in the bottom of the bag should not be used.
VERMICULITE
Sprinkle vermiculite around the charcoal embers.
Note: Note: Both charcoal embers and vermiculite are not to Note: Note: Note:
be placed on the burner.
CHARCOAL LUMPS
Place the lumps between the logs in a realistic manner
taking care not to block any of the burner ports.
#5
#6
W415-0377 / 03.04.03
9