8.0 WIRING DIAGRAM
This appliance comes equipped with a battery back-up. If this backup is used install four AA batteries (not
supplied) into the holder and connect to the wire harness. Place near the IPI board. Connect the battery holder
to the wire harness before using the appliance. Place near the IPI board. (Batteries not included). If backup is
used, it must be connected to the 6 volt battery pack supplied.
DC BACK-UP
-
+
TRANSFORMER
+
-
DC SUPPLY
DO NOT WIRE 110 VOLTS TO THE VALVE OR WALL SWITCH.
ACS/IPI
SWITCH
(OPTIONAL)
ON / OFF
SWITCH
IPI / CPI
ON / OFF
DISCONNECT THESE
CONNECTORS TO THE
ON/OFF SWITCH AND
CONNECT TO
OPTIONAL
THERMOSTAT .
WARNING
!
GROUND
EYELET
GROUND
GREEN
ORANGE
VALVE
ELECTRONIC
VALVE
IPI BOARD
69.5
W415-0788 / B / 11.03.10
41
DFC