Flame Generation Lamp Replacement - Napoleon EF30G Installation And Operating Instructions Manual

18
6.1

FLAME GENERATION LAMP REPLACEMENT

6.1.1 Remove the 7 screws from the bottom half of the
back of appliance illustrated. Remove back plate.
6.1.2 Locate the fl ame generation cylinder drum. It is
constructed of two removable halves. They are two
(2) matte black sheet metal pieces with holes in them,
either of which can be removed from the appliance.
6.1.3 Remove the screw as illustrated, that is used to
secure the fl ame generation cylinder drum.
6.1.4 Squeeze half of drum cylinder until its top edge clears
the top drum track. Remove the bottom edge of the
cylinder drum from the bottom drum track. This will
give you access to the lamps. NOTE: Do not exert
excessive pressures on the drum cylinder as this
may cause damage.
6.1.5 Remove spring clip. Hold socket and pull out old
lamp.
6.1.6 Hold socket and push in new lamp (DO NOT exceed
wattage). Replace spring clip.
6.1.7 Repeat steps 3 and 4 for the second lamp.
6.1.8 Insert bottom edge of removed cylinder half into
bottom drum track. Gently squeeze drum cylinder
until its top edge fi t into top drum rack. Reattach the
screw that was removed in step 2.2.
6.1.9 Secure the back plate of the appliance to the main
appliance by reattaching the 7 screws removed from
step 1.
W415-0760 / A / 01.18.10
BACK PLATE
Back View of Appliance
2 Screws
On The
Side
3 Screws On
The Back
FLAME GENERATION CYLINDER
DRUM
Flame Generation
Cylinder Drum
Screw
FLAME GENERATION CYLINDER
DRUM
Flame Generation Cylinder
Squeeze
DRUM LAMP REPLACEMENT
Bulbs with Spring
Clips
Mantel
2 Screws
On The
Side
Drum
Flame Generation
Cylinder Drum