Enabling And Disabling Parksense; Service The Parksense® Rear Park Assist System - Jeep grand cherokee 2015 Owner's Manual

Enabling And Disabling ParkSense®
ParkSense® can be enabled and disabled with the
ParkSense® switch.
When the ParkSense® switch is pressed to disable
the system, the instrument cluster will display the
"PARKSENSE OFF" message for approximately
five seconds. Refer to "Driver Information Dis-
play (DID)" in "Understanding Your Instrument Panel" for
further information. When the shift lever/gear selector is
moved to REVERSE and the system is disabled, the DID will
display the "PARKSENSE OFF" message for as long as the
vehicle is in REVERSE.
The ParkSense® switch LED will be ON when ParkSense®
is disabled or requires service. The ParkSense® switch LED
will be OFF when the system is enabled. If the ParkSense®
switch is pressed, and the system requires service, the
ParkSense® switch LED will blink momentarily, and then
the LED will be ON.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 229
Service The ParkSense® Rear Park Assist
System
During vehicle start up, when the ParkSense® Rear Park
Assist System has detected a faulted condition, the
instrument cluster will actuate a single chime, once per
ignition cycle, and it will display the "PARKSENSE
UNAVAILABLE WIPE REAR SENSORS" or the
"PARKSENSE UNAVAILABLE SERVICE REQUIRED"
message. Refer to "Driver Information Display (DID)" for
further information. When the shift lever/gear selector is
moved to REVERSE and the system has detected a
faulted condition, the DID will display the PARKSENSE
UNAVAILABLE WIPE
PARKSENSE UNAVAILABLE SERVICE REQUIRED
message for as long as the vehicle is in REVERSE. Under
this condition, ParkSense® will not operate.
REAR SENSORS or
3