Linking And Unlinking The Remote Keyless Entry Transmitter To Memory - Jeep grand cherokee 2015 Owner's Manual

162 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
• To set a memory profile to your RKE transmitter, refer
to "Linking And Unlinking The Remote Keyless Entry
Transmitter To Memory" in this section.
Linking And Unlinking The Remote Keyless Entry
Transmitter To Memory
Your RKE transmitters can be programmed to recall one
of two pre-programmed memory profiles by pressing the
UNLOCK button on the RKE transmitter.
NOTE: Before programming your RKE transmitters you
must select the "Memory To FOB" feature through the
Uconnect® system screen. Refer to "Uconnect® Settings "
in "Understanding Your Instrument Panel" for further
information.
To program your RKE transmitters, perform the follow-
ing:
1. Cycle the vehicles ignition to the OFF position.
2. Select a desired memory profile (1) or (2).
NOTE: If a memory profile has not already been set,
refer to Programming The Memory Feature in this
section for instructions on how to set a memory profile.
3. Once the profile has been recalled, press and release
the SET (S) button on the memory switch.
4. Within five seconds, press and release button (1) or (2)
accordingly. "Memory Profile Set" (1 or 2) will display
in the instrument cluster.
5. Press and release the LOCK button on the RKE
transmitter within 10 seconds.
NOTE: Your RKE transmitters can be unlinked to your
memory settings by pressing the SET (S) button, and
within 10 seconds, followed by pressing the UNLOCK
button on the RKE transmitter.