Linkages And Servo Neutral Adjustment 連桿及伺服機中立點調整 - THUNDER TIGER Raptor E550S Instruction Manual

LINKAGES AND SERVO NEUTRAL ADJUSTMENT 連桿及伺服機中立點調整
■ Lengths of Linkage Rods 連桿長度設定值
The proper lengths of linkages on the helicopter have
been setup correctly at Factory, but may need to be
slightly adjusted per the actual conditions.
直昇機上連桿已由原廠組裝完成，但長度可能仍需視實際情
況略做調整。
■ Servo Neutral Position 伺服機中立點
Adjust the Pitch and Throttle Curves as a -45° straight
line (from 0 to highest 100% and pass through the
mid-point 50%) on your transmitter firstly. Refer the
figure below to ensure every servo is at its neutral
positions when the sticks of transmitter are at its neutral
position before setting the corrective pitch. Refer your
transmitter manual to adjust the "Sub-Trim" values if the
servos are not at its neutral position.
首先將油門曲線設定為負斜率之對角線。參閱右圖，確認所有
伺服機皆正確對應遙控器撥桿中立點位置。如果伺服機偏離中
立點，請參閱您的遙控器說明書使用"Sub-Trim"進行微調。
Tail Servo
尾舵伺服機
32.5mm
55mm
148.8mm
Elevator Servo
升降舵伺服機
-7-
98.5mm
75mm
126mm
Length measured from ball link center to
ball link center
由此連桿頭中心測量至另一頭連桿頭中心
Both Stickers are at
their neutral positions.
撥桿皆位於中立點位置
Pitch Servo
螺距伺服機
L M H
[Pitch / Throttle Curve]
Point L : 0%
Point M : 50%
Point H : 100%
Aileron Servo
副翼伺服機