Servo Installation / 伺服機裝配 - THUNDER TIGER miti titan v2 Instruction Manual

SERVO INSTALLATION / 伺服機裝配
Bag P
No. Material No. Description
1 HMC2-8B SOCKET SCREW M2×8
Secure all screws shown on this page with a drop of thredlocker.
本頁顯示之螺絲請使用適量防鬆膠鎖固。
HMC2-8B
Socket Screw M2×8
M2×8
內六角螺絲
Must be purchased separately
改裝品需另購
Step 2 / 步驟二
1. Remove all the servo wheels prior to attaching the Linkage Balls.
2. Mount the Linkage Balls at 12.5mm from the center of the servo arms.
3. Secure the servos to the left and to the back, attach the rods to the servo arms.
1. 從伺服機上將另外兩組伺服機擺臂拆下，安裝連桿頭。
2. 將連桿頭安裝於距離擺臂中心位置12.5mm處。
3. 將完成連桿頭安裝伺服機安裝於伺服機固定座左側與後側，並與連桿連接。（後側伺服機擺臂連桿頭朝外）
(1)
T22
T22
(1)
Must be
purchased separately
改裝品需另購
名稱
M2×8
內六角螺絲
Step 1 / 步驟一
1. Remove the servo wheel prior to attaching the Linkage Ball.
2. Mount the Linkage Ball at 12.5mm from the center of the servo arm.
3. Secure the servo to the right Servo Tray and attach the rod to the servo arm.
1. 從伺服機上將伺服機擺臂拆下，安裝連桿頭。
2. 將連桿頭安裝於距離擺臂中心位置12.5mm處。
3. 將完成連桿頭安裝伺服機安裝於伺服機固定座右側，並與連桿連接。（左右側伺服機擺臂連桿頭朝內）
Qty
6
(1)
(1)
T22
-21-
T22
T22
(1)
T22
(1)