Esc Setting 電子調速器設定 - THUNDER TIGER Raptor E550S Instruction Manual

ESC SETTING 電子調速器設定
CAUTION / 警告
To connect the Lipo battery pack to ESC is necessary at this step. For safety, please ensure the motor has been
deactivated (or disengage the pinion gear from the main gear), and will not drive the main rotor before performing
this step!
在此設定程序中，必需將鋰電池連接至電子調速器。安全起見，請再次確認馬達不會被啟動（或將馬達齒脫離主齒盤），且不會
驅動主旋翼。
All the parameters of the ESC (Electric Speed Controller) had been set at Factory, the only setting you need to do is
the Throttle Calibration:
電子調速器各項參數已由原廠內建完成，您只需進行油門校正程序即可：
The calibration procedure always must be preformed if a new transmitter is being used.
當新使用，或更換遙控器時，請務必執行校正程序。
1. Power on the transmitter and place the throttle stick at full throttle position.
開啟遙控器，將油門撥桿置於全油門位置。
2. Power on the receiver if do not the built-in BEC.
如未使用內建BEC功能，請開啟接收機。
3. Connect Lipo battery pack to ESC and wait for 2 seconds.
將鋰電池組（另購）連接至ESC，等待2秒。
4. You will hear 2 tones (Beep-Beep-) from the ESC, which means the full throttle position has been calibrated.
ESC會發出2聲"嗶"響，表示全油門位置已完成校正並紀錄。
5. Move the throttle stick to the idle position (lowest position) for about 1 second, and then you will hear several tones.
(Depending on the cell number of battery pack you used, but normally 6-tone since the E550S using a 6-cell Lipo pack
as standard)
將油門撥桿移至最低點並等待1秒，此時ESC會發出數聲音響（音響數取決於您所使用的電池組片數，但通常本直昇機標準配備
是使用6S鋰電池組（6聲"嗶"響））。
6. A long Beep- tone means the idle throttle position has been calibrated and now the ESC is ready to go.
當聽到ESC發出一長"嗶"聲時，表示油門最低點位置已完成校正並紀錄，此時ESC已完成校正程序並已可正常使用。
7. Power off the receiver/disconnect the Lipo battery pack from ESC, and then your transmitter.
關閉接收機電源/斷開鋰電池組與ESC間的連接，然後再關閉發射機電源。
Please refer the ESC instruction manual to read more detailed information if any default settings need to
be changed.
如有任何設定需要變更，敬請參閱電調說明書以獲得更詳細的資訊。
CAUTION / 警告
Congratulates all the setting on the grand had been done for now. Next section of setting will be moved on the
flying field and need to take your helicopter off. Therefore, it is strongly recommended to seek helps and guidance
from accomplished pilots if you were a newcomer to the RC helicopters!
至此，您已完成所有的靜態設定。下一步設定需要至飛場進行，並將直昇機升空，如果您是剛接觸模型直昇機的初學者，我們
強烈建議您尋求有經驗的玩家給予協助及指導!
-9-