Table of Contents
Advertisement
19.Use furnished Allen Wrench to secure the collar
in place with 3x3mm set screws. Make sure the
wheel rotates freely.
20.Locate the EDS (electric drive system) and
remove the spinner and nuts. Note: Remove the
nose cone by rotating it counter-clockwise about
1/4 turn.
1/4
21.Secure the EDS with furnished two 3x20 self-
tapping screws. Thread the Controller (ACE
ESC-10) wire through the firewall from inside of
fuselage then connect to the motor wire firmly.
You may apply a piece of tape to prevent from it
loose. Next thread the wire back to fuselage.
3x20mm
SERVO, ESC,RX & BATTERY INSTALLATION
22.Drill 1/16" hole on the molded dot of the cowling.
23.Apply cowl decals first then secure the cowl in
place with two 2 x 8 mm wood screws.
Servo, ESC, RX & Battery Installation
24.Apply thin double side tape on the micro servos
as shown.
25.Remove a foam spacer from the servo well.
Glue the micro servo to the wall of servo well.
8
1.5mm
2x8mm
Advertisement
Table of Contents
