System Installation; Base Unit; Gateway; Rp Phones - Aastra 6751i RP Administrator's Manual

System Installation

The AastraLink RP Solution uses auto-discovery to sense the system components. Before installing the Response Point
software on the system administrator's PC, all other components of the AastraLink RP Solution must be installed, plugged
in, turned on (if applicable), and connected to the LAN.
Note: All phones, base units and gateways must be connected to the same LAN in order for the AastraLink RP Solution to
function as designed.

Base Unit

The AastraLink 500 Base Unit should be installed following the instructions given in the AastraLink 500 Base Unit
Installation Guide or AastraLink RP Solution Quick Start Guide.
The AastraLink 500 Base Unit may be installed as a desktop unit flat on the desk or on end, or may be wall-mounted to save
space.
The AastraLink 500 Base Unit must be connected to power, to the LAN, and must be turned on for auto-discovery to
succeed.

Gateway

The AastraLink RP 540 Gateway should be installed following the instructions given in the AastraLink 540 Base Unit
Installation Guide or AastraLink RP Solution Quick Start Guide.
The AastraLink RP 540 Gateway may be installed on a desktop, stacked under an AastraLink RP 500 Base Unit, or wall-
mounted.
The AastraLink RP 540 Gateway must be connected to power and to the LAN, and must be turned on for auto-discovery to
succeed.

RP Phones

Any combination of Aastra phone models 6751i RP, 6753i RP and 6757i CT RP works with the AastraLink RP Solution.
4 AastraLink RP System Administrator Guide