Muratec MFX-1300/1700 Operating Instructions Manual page 133

Just in case
Reception errors
. 1 . 1 The calling fax machine didn t respond to your fax machine. This can happen if
R
someone dials a wrong number or if the remote machine restricts access
through use of a passcode.
. 1 . 2 The two fax machines were incompa t i b l e . Your fax machine sends and receives
R
only - Group 3 (see Glossary, page 5.18) fax communication, the industry
ITU T
s tandard since the early 1980s.
. 1 . 4 Someone pressed
R STO P
. 2 . 3 Poor phone line conditions made fax communication impossible. Call someone
R
at the remote machine s location.
. 3 . 1 The sending fax machine detected too many errors from the receiving
R
fax machine.
. 3 . 3 The sending fax machine is incompatible or had a document feeder problem
R
during transmission.
. 3 . 4 Poor phone line conditions may have prevented your fax machine from properly
R
printing some or all of the pages it received.
. 4 . 2 Either the line disconnected before transmission or the transmitting fax machine
R
needs maintenance.
. 4 . 4 The fax machine has reached its memory capa c i t y.
R
. 5 . 1 , reception failed (perhaps due to line noise).
R E C M
. 5 . 2
R
. 8 . 1 A compatibility error occurred.
R
.8.10 Line noise or other problems prevented line probing.
R
. 8 . 11 The fax machine timed out while waiting for the retrain signal.
R
Transmission errors
. 1 . 1 The remote fax machine didn t respond to your machine. Call someone at the
T
remote machine s location.
. 1 . 2 Your fax machine s page counter detected a possible document feeder error.
T
Carefully put the document back into the feeder and try the call again.
. 1 . 4 was pressed during transmission.
T STO P
. 2 . 1 Either the phone line disconnected during transmission or fax communication
T
became impossible due to bad phone line conditions. Try the call again.
. 2 . 2 The two fax machines were incompa t i b l e . Your fax machine sends and receives
T
only - Group 3 (see Glossary, page 5.18) fax communication, the industry
ITU T
s tandard since the early 1980s.
5.10
at the receiving fax machine.
. 2 . 3 Bad phone line conditions made fax communication impossible. Conditions can
T
change rapidly, so try the call again later.
. 3 . 1 The page counter in your fax machine detected a document feeder error during
T
transmission. Carefully re-insert the document into the feeder and re-try the call.
. 3 . 2 The fax machine didn t detect the silence indicating the call had ended.
T
. 4 . 1 The telephone line disconnected during transmission because of excessive
T
modem errors or because remote unit ran out of paper.Try the call again.
. 4 . 2 A fter transmission began, poor line conditions developed. Try the call again.
T
. 4 . 4 Poor line conditions prevented transmission. Try the call again.
T
. 5 . 1 , transmission failed (perhaps due to line noise). Conditions can change
T E C M
. 5 . 2 , rapidly, so try the call again later.
T
. 5 . 3
T
. 8 . 1 A compatibility error occurred.
T
.8.10 Line noise or other problems prevented line probing.
T
. 8 . 11 The remote fax machine didn t complete the equalizer training phase.
T