Table of Contents
Advertisement
Main Menu
Table of Contents
Replacing a Rear Turn Signal or
Brake Light Bulb
Remove the two bolt covers on the
1.
rear pillar by prying on the bottom
edge with a flat-tip screwdriver.
Remove the bolts with a Phillips-
head screwdriver, and remove the
light assembly from the rear pillar.
2.
Determine which of the two bulbs
is burned out: turn signal or
brake/taillight.
3.
Remove the socket by turning it
one-quarter turn counterclockwise.
4.
Remove the bulb by pulling it
straight out of its socket.
Push the new bulb straight into
the socket until it bottoms.
5.
Test the lights to make sure the
new bulb is working.
6.
Put the socket back into the light
assembly, and turn it clockwise to
lock it in place.
7.
Install the rear light assembly in
the rear pillar. Tighten the two
bolts. Snap the bolt covers into
position.
Lights
347
Advertisement
Table of Contents
