Table of Contents
Advertisement
Main Menu
Table of Contents
HomeLink Universal Transceiver
6.
Push and hold the HomeLink
button for a few seconds, then
watch the red indicator on
HomeLink.
If the indicator stays on or
flashes slowly, repeat steps 2
thru 5.
If the indicator flashes rapidly
for 2 seconds then stays on, you
have a rolling code transmitter:
Go to ''Training with a Rolling
Code System'' (see page
7.
Repeat these steps to train the
other two HomeLink buttons to
operate any other compatible
remotely controlled devices
around your home (lighting,
automatic gate, security system,
etc.).
274
Training With a Rolling Code
System
For security purposes, newer garage
door opening systems use a ''rolling''
or variable code. Information from
the remote control and the garage
door opener are needed before
HomeLink can operate the garage
door opener.
The ''Training HomeLink''
274
).
procedure trains HomeLink to the
proper garage door opener code.
The following procedure
synchronizes HomeLink to the
garage door opener so it sends and
receives the correct codes.
1.
Make sure you have properly
completed the ''Training
HomeLink'' procedure.
Find the ''training'' button on your
2.
garage door opener unit. The
location will vary, depending on
the manufacturer.
TRAINING BUTTON
Press the training button on the
3.
garage door opener unit until the
indicator next to the button comes
on. The indicator may blink, or
come on and stay on. You then
have approximately 30 seconds to
complete the following steps.
Advertisement
Table of Contents
