Table of Contents
Advertisement
RAS96 RASCard User Guide
Introduction
This chapter describes how to install the RAS96 RASCard into a CommPlete
Communication Server chassis (either CC9600 or CC2400). This equipment should be
installed only by a qualified service person.
Safety Warnings
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jacks are specifically
designed for wet locations.
• Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
• Avoid using a telephone (other than a cordless type) during an electrical storm.
There may be a remote risk of electrical shock from lightning.
• Do not use the telephone to report a gas leak in the vicinity of the leak.
• Ports that are connected to other apparatus are defined as SELV. To ensure con-
formity to EN 41003, ensure that these ports are only connected to the same type on
the other apparatus.
Pre-Installation Notes
Warning: Interconnection directly, or by way of other apparatus, of ports marked
"SAFETY WARNING see instructions for use" with ports marked or not so marked
may produce hazardous conditions on the network. Advice should be obtained from a
competent engineer before such a connection is made.
• All installation must be done by a qualified service person.
• To reduce emissions, be sure to use blanking plates to cover empty slots in the
CommPlete chassis.
Installation Procedure
1.
2.
3.
4.
14
Unpack the RAS96 RASCard assembly from its packaging and save the
packaging for possible future use. Perform a visual inspection of the RASCard. If
you are concerned about its condition, call Technical Support for instructions.
The RASCard must be installed in slot 1, 5, 9, or 13 of the CC9600 chassis, or in
slot 1 of the CC2400 chassis (counting left to right). Remove a blank RASCard
panel or previous RASCard from that slot.
Replace the back cover plate with one that has openings for the RASCard.
Make sure the power switch on the RASCard is off.
CommPlete Communications Server
Advertisement
Table of Contents
