Panasonic WV-CZ392E: WV-CZ492E Operating Instructions Manual page 24

Note:
• When the selected shutter speed caused
flicker on condition that fluorescent lamps
stay on, change this setting to "OFF".
• When "MANUAL" is selected for "ALC/
MANUAL" and "FIX" is selected for "SENS UP",
"AUTO" can be selected for "SHUTTER", but
the AUTO function is not available.
4 Gain Control Setting
Select "ON (LOW)", "ON (MID)", "ON (HIGH)" or "OFF".
Default setting: ON (MID)
Note:
• Even if "AGC" is set to "ON" and if the noise
reduction functionis enabled, after images may
be produced by shooting a moving object.
• For more information, refer to Digital
Noise Reduction on page 25.
5 SENS UP Setting
The electronic sensitivity enhancement
mode changes as follows:
OFF AUTO
AUTO
FIX
FIX 128
When "OFF" is selected for "SUPER-D6",
the electronic sensitivity enhancement
mode changes as follows:
OFF AUTO
AUTO
FIX
FIX
When "ON" is selected for "SUPER-D6",
the electronic sensitivity enhancement
mode changes as follows:
AUTO
OFF
Default setting: OFF
Note:
• The difference between "AUTO" and "FIX"
are as follows:
AUTO: If selected "X32 AUTO", SENS UP
will increase up to X32 automatically.
24
CZ392
AUTO AUTO
AUTO OFF FIX
FIX FIX FIX
FIX 256 FIX 512
CZ492
AUTO AUTO
AUTO OFF FIX
FIX FIX FIX
128 FIX 256 FIX 512
CZ492
FIX: If selected "X32 FIX", SENS UP will
• Noise or spots may appear in the picture
when the sensitivity of the camera is
increased.
6 White Balance Setting
1. ATW1/ATW2: in this mode, the camera
ATW1: 2700 K to 6000 K.
ATW2: 2000 K to 6000 K (Mode
Default setting: ATW1
Proper white balance may not be possible
under the following conditions. In such
cases, use the "AWC" while balance mode.
• When the subject contains mostly dark
colors
• When the light source is a deep blue sky
or twilight
• When illumination of the subject is low
(1) The white balance of the camera is
AUTO
automatically adjusted at ATW1 and ATW2.
FIX
FIX
AUTO
FIX
(2) For fine adjustment of ATW1/ATW2, press the
[SET] button. The ATW1/ATW2 fine adjustment
FIX
menu appears on the monitor screen.
2. AWC: Automatic White Balance Control
In this mode, the supported color
temperature range is approximately 2000 K
to 10000 K. This mode is best in locations
where the light source is constant.
(1) Select "AWC" and press the [SET] button.
(2) "PUSH SET" is highlighted on the display
while white balance adjustment is being
performed.
• "PUSH SET" becomes unhighlighted again
when white balance adjustment is complete.
increase up to X32 fixedly.
continually monitors the
color temperature of the light
source and automatically
adjusts white balance.
recommended for sodium lighting)
**AWT1**
R ···I··· 0
B ···I··· 0
RET TOP