Detaching the dome cover
Detach the dome cover from the camera by loosening the dome cover fixing screws.
SF549
SF548
The following procedure is required when using WV-SF549 or WV-SF548. Refer to page 18 when
using WV-SF539 or WV-SF538.
IMPORTANT:
• Remove the cover film from the dome section of the dome cover after the installation is com-
plete. Do not touch the dome section by hand directly after removing the cover film.
z
Loosen the dome cover fixing screws using
the bit for tamperproof screw (accessory).
Note:
• The dome cover and the camera are joint-
ed with an assist wire. Do not remove the
assist wire.
17