Preparations; Remove The Dome Cover - Panasonic WV-CF374E Installation Manual

Preparations

When installing the camera on a wall or ceiling, there are three methods as specified below.
• Use the one-gang junction box
• Installing the camera directly on a wall or ceiling
• Using the optional ceiling mount bracket WV-Q174E (for embedded installation on a ceiling)
Important:
• Procure 2 screws (M4) to secure the camera to a wall or ceiling according to the material of the
installation area. Do not use wood screws and nails. For mounting a camera on a concrete wall
or ceiling, use an anchor bolt (M4) for securing.
(Recommended tightening torque M4: 1.6 N·m)
• Required pull-out strength of a single screw/bolt is 196 N or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the installation
area shall be sufficiently reinforced.
• The protection sheet attached to the dome section should be peeled off after installation.
The mounting conditions of the camera are described as follows:
Installation Applicable mount
place bracket
One-gang junction box
Ceiling / wall
(locally procured)
Ceiling / wall (Direct mounting)
WV-Q174E (approx. 310 g) -
Ceiling
*1 Make sure that the installed mount bracket can support more than 5 times of the weight of the cam-
era.
 Remove the dome cover
1 Peel off the protection sheet from the dome
cover. Don't remove completely as this
protects the dome during installation.
Loosen the dome cover fixing screw.
2
Adjust the mark on this unit to [|] on the
3
dome cover, and turn the dome cover
counterclockwise to remove it.
Note:
• The clear dome cover and the inner dome
are joined into a single unit.
Therefore, never try to remove them.
Recommended Number
screw of screw
M4 2 pcs.
M4 2 pcs.
-
Minimum pull-out
strength (per 1 pc.)
196 N
196 N
*1
Mark
Mark [|]
13