Table of Contents
Advertisement
MT2834ZPX Owner's Manual
Remote Configuration
The Remote Configuration feature is a network management tool that
allows you to configure modems remotely. This means you could
configure modems anywhere in your network from one location without
having to visit the sites or rely on remote users to follow your
instructions. With Remote Configuration, which is protected by two
level security, you can downline load new parameters, program new
V.42 capabilities and implement new features. Remote Configuration
also makes troubleshooting a remote location a lot easier.
The way Remote Configuration works is that S-Register S13 has been
set-up to contain the special Remote Configuration escape code.
When calling a Remote Configuration equipped modem, you enter the
proper Remote Escape code to enable entering your Set-up
Password. After entering it, you can then execute AT commands as if
you were connected locally. If you set S-Register S13 to zero,
Remote Configuration is disabled.
Remote Configuration Procedures
The procedures for using the Remote Configuration features are the
same whether or not a call originates from the remote modem. Once
the modem is on-line, perform the procedures in Table 4-1.
TABLE 4-1. Remote Configuration Operation Procedures
Step
1.
Remote Escape Configuration requires %%%<CR> to be
sent if the default value in S-Register S13 has not been
changed.
The modem responds with:
2.
You then select 1 or 2 . With 1, the modem goes
back into data mode and with 2, the modem re-
sponds with the following:
3.
Enter your Set-up Password, and if the code is
correct the modem responds with:
38
Procedure
1. - DATA Mode
2. - COMMAND Mode
Password>
OK
Advertisement
Table of Contents
