Table of Contents
Advertisement
COMMAND:
$MB n
VALUES:
n = speed
DEFAULT:
$MB33600 bps
DESCRIPTION:
$MB75 selects CCITT V.23 mode.
$MB300 selects 300 bps on-line.
$MB1200 selects 1200 bps on-line.
$MB2400 selects 2400 bps on-line.
$MB4800 selects 4800 bps on-line.
$MB9600 selects 9600 bps on-line.
$MB14400 selects 14400 bps on-line.
$MB19200 selects 19200 bps on-line.
$MB28800 selects 28800 bps on-line.
$MB33600 selects 33600 bps on-line.
COMMAND:
N d
VALUES:
d = 0 thru 9
DEFAULT:
n/a
DESCRIPTION:
Dial stored telephone number "d" (Do not
COMMAND:
N d N e
VALUES:
d = 0 thru 9; e = any other number 0 thru 9
DEFAULT:
n/a
DESCRIPTION:
Number Linking. If first number dialed is
COMMAND:
O
VALUES:
n/a
DEFAULT:
n/a
DESCRIPTION:
Exit Command Mode and go into On-Line Mode.
COMMAND:
P
VALUES:
n/a
DEFAULT:
Tone Dial
DESCRIPTION:
Modem will pulse-dial numbers following the P.
Chapter 4 - AT Commands, S-Registers and Result Codes
include the letter D in this command.)
busy, another stored number may be
automatically dialed.
31
Advertisement
Table of Contents
