Table of Contents
Advertisement
COMMAND:
Un
VALUES:
n = 0, 1, 2, or 3
DEFAULT:
n/a
DESCRIPTION :
U0 places modem in Analog Loop Originate Mode.
U1 places modem in Analog Loop Answer Mode.
U2 places modem in Remote Digital Loopback
U3 places modem in Local Digital Loopback Test Mode.
COMMAND:
Vn
VALUES:
n = 0 or 1
DEFAULT:
V1
DESCRIPTION :
V0 selects Result Codes sent as digits(terse response).
V1 selects Result Codes sent as words (verbose response).
COMMAND:
#Vn
VALUES:
n = 0 or 1
DEFAULT:
#V1
DESCRIPTION :
User can bypass V.32terbo handshaking process.
COMMAND:
W
VALUES:
n/a
DEFAULT:
n/a
DESCRIPTION :
Wait for new dial-tone.
COMMAND:
&Wn
VALUES:
n = 0 or 1
DEFAULT:
&W1
DESCRIPTION :
&W0 causes modem to store its current parameters in
nonvolatile RAM, and modem will load these for future ses-
&W1 causes modem to not store parameters.
Chapter 4 - AT Commands, S-Registers and Result Codes
test mode.
#V0 selects V.32terbo enabled in originate/answer modes.
#V1 selects V.32terbo disabled in originate/answer modes.
sions instead of reading factory ROM defaults, unless &F
command used.
35
Advertisement
Table of Contents
