Multitech MultiModem MT2834ZPX Owner's Manual page 34

MT2834ZPX Owner's Manual
COMMAND: &Sn
VALUES: n = 0, 1 or 2
DEFAULT: &S1
DESCRIPTION :
&S0 forces Data Set Ready On.
&S1 lets Data Set Ready act normally.
&S2 Data Set Ready drop is regulated by
COMMAND: T
VALUES: n/a
DEFAULT: Tone Dial
DESCRIPTION :
Modem will tone-dial numbers following the T.
COMMAND: &Tn
VALUES: n = 4 or 5
DEFAULT: &T5
DESCRIPTION :
&T4 selects Enable Response to Request for
Remote Digital Loopback.
&T5 selects Disable Response to Request for
Remote Digital Loopback.
COMMAND: $Tn
VALUES: n = 1 or 2
DEFAULT: $T1
DESCRIPTION :
$T0 selects calling tones on (1300 Hertz data/modem
$T1 selects calling tones off (1300 Hertz data/modem
COMMAND: #Tn
VALUES: n = 0 or 1
DEFAULT: #T1
DESCRIPTION :
#T0 turns off Trellis Coded Modulation
#T1 turns on Trellis Coded Modulation
34
S24 on disconnect.
mode only).
mode only).