Operating Information; Setting The Analog Input Level; Using A T1 Tonematch; Audio Engine And An Analog Input Source - Bose L1 model II Owner's Manual

Hide thumbs Also See for L1 model II:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
English
English
Dansk
Deutsch
Español
Dansk

Setting the analog input level

Using a T1 ToneMatch

User scenarios

Figure 1
Single L1 model II system
with keyboard
Français
Deutsch
Italiano
Nederlands
Español
When connecting an audio source to the Analog Input, follow these steps to adjust the input
Trim control.
1. Set the Trim control on the power stand to the 0 (zero) position.
2. Connect the audio source to the Analog Input.
3. Adjust the volume of the audio source to the desired level.
4. While playing the source, increase the Trim level until the Signal/Clip indicator glows
green or yellow.
5. If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green
or yellow.
®

audio engine and an analog input source

The L1
®
model II system can operate with both a T1 ToneMatch
audio source connected to the power stand. However, keep in mind that the volume level of
the audio engine and the analog audio source is adjusted independently.
• The power stand Trim control only affects the volume level of the analog audio source con-
nected to the Analog Input. Therefore, the Signal/Clip indicator indicates the status only
of the analog input signal.
• The T1 ToneMatch audio engine has a Trim control and signal/clip indicator for each input,
a Volume control for each output channel, and a Master volume control that adjusts the
level of the ToneMatch output sent to the power stand. These controls have no effect on
the signal fed to the Analog Input.
There are many ways to set up and use this system with and without the T1 ToneMatch audio
engine. The following pages show examples of some typical user scenarios. When using the
T1 ToneMatch audio engine, refer to its owner's guide for more information on setup and
operation.

Single musician

A solo musician might play a single instrument through the L1 model II system (Figure 1). 
A solo musician also might play an instrument and use a microphone for vocals (Figure 2 on
page 18).
Français
Svenska
Italiano
O
PERATING
Nederlands
Svenska
I
NFORMATION
®
audio engine and an analog
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents