Adding A Second B1 Bass Module (Optional) - Bose L1 model II Owner's Manual

Svenska Nederlands
S S
YSTEM ETUP

Adding a second B1 bass module (optional)

Figure 7
Installation of two B1 bass
modules
14
Italiano Français Svenska
The bass module output of the power stand can adequately drive one or two B1 bass 
modules. When placed horizontally, the modules are stackable (Figure 7).
One or two additional B1 modules can be added with the use of a PackLite
Refer to "Adding a PackLite
CAUTION: Do not connect more than two B1 bass modules to the Bass Module Out
connector on the power stand. Driving more than two B1 bass modules from this output
improperly loads the amplifier in the power stand, resulting in less than full system performance.
1. Connect the first B1 to the Bass Module Out connector on the power stand.
2. Plug one end of the second B1 cable into the unused connector of the first B1. Plug the
other end of the cable into one of the connectors of the second B1.
Second B1
bass module
cable
First B1 bass
module cable
Nederlands Español Français Deutsch Italiano
® power amplifier model A1 (optional)" on page 15.
Deutsch Español Dansk English English
®
power amplifier.
Bass Module Out
Dansk

