Turning The Scansnap On/Off - Fujitsu ScanSnap S1500M Operator's Manual

Turning the ScanSnap ON/OFF

This section explains how to turn the ScanSnap ON/OFF.
The ScanSnap is turned ON/OFF in conjunction with the computer. Therefore, you do not
have to worry about turning the power ON/OFF as long as the ScanSnap is connected to a
computer.
Turning the ScanSnap on
Open the ADF paper chute (top cover) when the computer is turned on.
The [Scan] button flashes blue to indicate that the ScanSnap is turned on, and lights in
blue when the ScanSnap is ready to scan.
Turning the ScanSnap off
Turn off the computer or close the ADF paper chute (cover).
The [Scan] button switches off when the ScanSnap is turned off.
With some computers, the initialization of the ScanSnap may be performed several
times when the computer is started up.
Close the ADF paper chute (cover) after putting the extension back.
Make sure to close the stacker firmly. If you close the ADF top section when the
stacker is loose, the ScanSnap will not be turned off.
With some computers, it may take two to three minutes until the light of the [Scan]
button goes out after the computer is turned off.
Turning the ScanSnap ON/OFF
27