VINCENT SA-T7 Instructions For Use Manual page 35

Operation
Switch off tone control
(BASS/TREBLE)
Change the brightness
of the tube window illu-
mination
Switching between
digital and analog
input signal
OPERATING THE APPLIANCE
Button(s) Description
If the sound is not to be changed, it is recommended that you switch off
the sound control (BASS, TREBLE) with this button on the front of the devi-
ce. When this button is pressed, the sound processing settings in the tone
TONE (4)
controllers (1)(3) come into play. If the button is not pressed, the two
sound controllers in the preamplifier are bypassed and the signals from the
source are not changed in terms of their frequency levels.
The display window for the visible tube (5) can be illuminated with one of
four brightness settings, if that is desired. Initially the brightness setting is at
maximum. By repeatedly pressing "DIMMER" all illumination levels are
DIMMER (15)
available. After switching off the preamplifier the brightness setting is
saved until you use the device again.
If you should have connected devices on the digital Inputs (13) by optical
and coaxial cable you can choose these inputs by pressing the button
Analog/Digital (8). Herefor move the control dial on S5/OPT (7) to choo-
ANALOG/ se a source which is connected by optical cable and S6/COA for choose
a source which is connected by coxial cable.
DIGITAL (8)
By not pushing the buttom the signal is passed by the analog inputs S5
and S6.
Vincent
35