VINCENT SA-T7 Instructions For Use Manual page 33

STANDBY CONTROL (POWER CONTROL)
trol are not disconnected from the mains network when switched off. They are set to a standby state inste-
ad. For connecting cables, two-core cables with 3.5 mm jack plugs (mono) are used. For each connecti-
on between two devices one of those cables is needed.
If you don't wish to use this function or if the other components do not support it, all you have to do is
leave out these cable connections.
The SA-T7 is equipped with two output connectors for the power control. Here, the switching signal gene-
rated by the SA-T7 is available for other components of the system. Two HiFi components that are able to
react to the power control signal can be connected directly to the amplifier's power control outputs. If more
than two devices, which can be controlled, are to be connected, then it is necessary to make the power
control connection between the amplifier and these further devices through the outputs of the two devices
which are connected directly. For that reason, every HiFi component that accepts power control signals is
also equipped with a power control output. Thus, in theory it is possible to provide an infinite number of
HiFi components with the power control signal. This approach, to loop a signal through a chain of com-
ponents, is commonly referred to as "daisy chaining".
SA-T7
Caution:
Many devices which can be controlled by a switching signal (not preamplifiers or integrated ampli-
fiers), have two terminals which do not differentiate between input and output. In this case either of
the two can be selected.
"POWER CONTROL" sockets of preamplifiers or integrated amplifiers must not be interconnected! All
receiving devices must not be connected to more than one preamplifier or integrated amplifier (direct-
ly or indirectly)!
CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and frequency
can be read on the back of the device beside the socket for the mains. If the electricity supply is appropriate,
push the inlet connector of the supplied mains cable firmly into socket for the mains on the back of the device.
Connect the other end of the mains cable to a mains socket.
CONNECTIONS FOR THE
power control cable
main amplifier
e.g. SP-T700
second main amplifier
e.g. second SP-T700
Vincent
33