Remote Control Unit - Denon DVD-2910 Operating Instructions Manual

ENGLISH
(3) Display
q w e r t y u
SUPER DVD GROUP TITLE TRACK CHAP ANGLE D.MIX PROG RAND TOTAL SING
AUDIO VCD
1 A-B
PROGRESSIVE
F V
!3 !4
q
Lights to indicate the currently playing disc.
w
Lights in the repeat play mode.
e
These light to indicate the names of sections of
the disc being played.
r
Lights during playback of multiple angles disc.
t
Lights when the audio signals can be down-
mixed.
y
Lights in the programmed play mode.
u
Lights in the random play mode.
i
There light to indicate the time display mode.
o
Lights when HDCD is playing.
!0
Lights when SRS TruSurrond is on.
!1
Lights to indicate the currently playing audio
format
!2
Lights to indicate the currently playing audio.
L : Front left channel
C : Center channel
R : Front right channel
SL : Surround left channel
S : Mono surround channel
SR : Surround right channel
LFE: Low frequency effect
12
i o !0 !1
REM HDCD DIGITAL
L.PCMP.PCM
L
MPEG JPEG
SL SL
WMA MP3 HDMI 480P 576P
IEEE1394 DVI 720P 1080i
!6 !7
!5
!3
Lights to indicate the currently playing video
type.
F :Film source
V :Video source
!4
Lights when progressive video signals are being
output.
!5
Displays the title , track number and elapsed
time during playback.
!6
Lights when the video (or audio) signals is
output from HDMI or DVI terminals.(Lights only
one of the HDMI or DVI.)
(Flashes while the connection to the DVI-D
or HDMI connector is being checked.)
!7
Lights to indicate the currently video format of
HDMI or DVI terminals.
(Flashes while the connection to the DVI-D
or HDMI connector is being checked.)
6

REMOTE CONTROL UNIT

The DVD-2910 can be controlled from a distance using the included remote control unit (RC-985).
2
!2
(1) Inserting Batteries
C R LFE LFE
S SR SR
q Remove the remote control unit's rear cover.
w Place two R6P/AA batteries in the battery
compartment in the direction indicated by the
marks.
e Close the rear cover.
(2) Using the Remote Control Unit
Approx. 7 meters
Cautions On Batteries
• Use R6P/AA batteries in this remote control unit.
• Replace the batteries with new ones approximately
once a year, though this depends on the frequency
with which the remote control unit is used.
• If the remote control unit does not operate from
close to the main unit, replace the batteries with
new ones, even if less than a year has passed.
• The included battery is only for verifying operation.
Replace it with a new battery as soon as possible.
• When inserting the batteries, be careful to do
so in the proper direction, following the < and
> marks in the remote control unit's battery
compartment.
• To prevent damage or battery fluid leakage:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or
dispose of batteries in flames.
• Remove the batteries when not planning to use
the remote control unit for a long period of time.
• If the batteries should leak, carefully wipe off the
fluid from the inside of the battery compartment,
then insert new batteries.
• When operating the remote control unit,
point it at the remote control sensor as
shown on the diagram.
• The remote control unit can be used from a
direct distance of approximately 7 meters.
This distance will be shorter, however, if
there are obstacles in the way or if the
remote control unit is not pointed directly
at the remote control sensor.
• The remote control unit can be operated at
a horizontal angle of up to 30° with respect
to the remote control sensor.
NOTES:
• It may be difficult to operate the remote
control unit if the remote control sensor is
exposed to direct sunlight or strong
artificial light.
• Do not press buttons on the main unit and
on the remote control unit at the same
time. Doing so will result in malfunction.