Step 2 - Connect And Secure The Drain Hose; Step 3 - Connect The Water Hose - Haier HLP24E User Manual

sTEP 2 - ConnECT anD sECURE THE DRaIn HosE

1. Enlarge the opening by squeezing the
ends of the drain hose clamp together.
Slide the clamp over the end of the drain
hose, and onto the flexible section of the
hose.
2. Fit the end of the drain hose over the
plastic drain port extending from the
washer.
3. Squeeze the ends of the clamp to enlarge
the opening and slide the clamp over the
connection of the drain hose and drain
port. Release the clamp to tighten.
4. Put the drain hose hook end in a drain pipe or laundry tub.
5. Secure the drain hose in place by fastening it to a water hose, the standpipe, or a
leg on the laundry tub. See "Drain System Requirements" for illustrations.

sTEP 3 - ConnECT THE WaTER HosE

IMPoRTanT: Only use a new hose when installing the washer.
noTE: Periodically inspect hose for cracks, cuts, leaks or wear. Replace with new
hose every 5 years.
1. Check that a flat washer is present and firmly in place in each end of the water
inlet hose. Flat washers are pre-installed at the factory.
A
Washer
9