Haier HLP24E User Manual page 12

2. Thread the inlet hose onto the water faucet by hand until snug. Then using pliers,
tighten an additional two-thirds turn.
IMPoRTanT: To avoid damage to the hose coupling, do not overtighten.
noTE: To avoid damage to the faucet do not use plumber's tape or sealants on
the valve threads.
3. Thread the other end of the inlet hose by hand onto the inlet valve on the back of
the washer until snug. Then using pliers, tighten an additional two-thirds turn.
IMPoRTanT: To avoid damage to the hose coupling, do not overtighten.
noTE: To avoid damage to the washer inlet valve, do not use plumber's tape or
sealants on the valve threads.
4. Turn on the water faucet and check for leaks. If there is any leaking, check steps
1 through 3 again.
10