Table of Contents
Advertisement
Installation & Adjustment
Please install and adjust the machine according to the directions contained in this
manual.It is very important to follow these directions to ensure the machine operates
correctly and safely.
Install the bottom plate
The purpose of the bottom plate is to reduce noise level from
the washing machine while operation in progress.
Steps:
1. Lay the machine on a flat and clean floor.
2. Place the plate onto the bottom of the machine.
3. Use a screwdriver to tighten the screw (in accessory bag)
securing the panel to bottom of the washer.
4. Once the screw is tight and the panel is secure, put the
appliance back in an upright position.
Balance washing machine
Do not install the machine on a tilted floor. Pleas install the machine on a level floor.
If the floor is not level, use the adjustable feet to adjust it. Keep the machine at 20mm
from each adjacent wall.
Change the direction of the drain hose
Lay the machine on a flat and clean floor.
Relocate the drain pipe in a diagonal
direction if required.
Applicable model: HWM120-B1678S8
2°
e
Screw
Bottom plate
5
Front
Back
Advertisement
Table of Contents
