Furuno 1824C Installation Manual page 54

Item
Fix Mode Choose position fixing method: 2D
(three satellites in view), 2D/3D (three
or four satellites in view whichever is
greater).
Cold Start Clears the Almanac to receive the latest
Almanac.
WAAS setup (requires GPS receiver GP-320B)
Press the WAAS SETUP soft key to show the WAAS SETUP display.
Item
WAAS Mode Select ON to use the WAAS mode.
WAAS WAAS satellite can be searched
Search automatically or manually. For manual
search, enter appropriate WAAS satellite
number.
WAAS Alarm When the WAAS signal is lost, the
audible alarm sounds with the visual
message "NO WAAS SIGNAL."
On: Alarm continues to sound until the
WAAS positioning mode is available
again or the alarm is recognized by key
operation.
Off: Alarm sounds three times.
Corrections Selects the type of message for WAAS
correction. Use "00" (operational status)
Data
in North America; "02" in other locations.
39. After you have finished setting up the GPS receiver, it's now time to set up external
equipment. Press the NEXT soft key to show the GPS/PORT menu. It is only necessary
to set up ports which you are going to use; skip unnecessary steps. If you do not have
external equipment connected to the NavNet, press the NEXT key several times to
show the "FINISH AND EXIT INSTALLATION WIZARD" screen and then push the
ENTER knob to finish.
OUTPUT FORMAT
LAT/LON FORMAT
OUTPUT DESTINATION NO
Installation wizard, GPS/PORT setup
Description
Contents of WAAS SETUP menu
Description
NMEA0183
Ver 2.0
DD'MM.MMM'
3-10
Settings Default Setting
2D, 2D/3D 2D/3D
No, Yes No
Settings Default Setting
On, Off Off
Auto, Manual Auto
On, Off Off
00 to 27, 99 02