Furuno 1824C Installation Manual page 38

DJ-1
For MODEL1824C/1834C/1934C/1944C/1954C, remove the waterproofing cap from DJ-1
port and discard it.
MODEL1824C/1834C:
MODEL1934C/1944C/1954C: Connect the MJ-B24LPF0005 cable from the power supply
GD-1920C:
Waterproofing cap and connector nut, sectional view
Ground terminal
Connect the ground wire (local supply, IV-2sq) between the ground terminal and ship's
ground.
DATA1 to DATA4
Other equipments can be connected here as shown below.
DATA1 (7P)
GPS receiver
GP-310B/320B
This equipment can receive the following NMEA 0183 format sentence from other
equipments. You will need the optional NMEA cable to connect with external equipment.
• Own ship's position:
• Time:
• Ship's speed:
• Other ship's information:
• Wind speed and angle:
• Heading (True):
• Heading (Magnetic
• Course:
• Depth:
• Waypoint
• Water temperature:
• Target data
• DSC information
Connect the MJ-B24LPF0002 cable from the antenna unit
to this port.
unit to this port.
Do not remove the waterproofing cap.
Wrap the connector nut and cap with vinyl tape as shown
below.
Waterproofing cap (yellow)
Connector nut (for 24P)
DATA2 (6P)
NMEA sentence Heading sensor (ex. SC-60/120)
(ex. Navaid) (MODEL series only)
GGA>RMC>RMA>GLL
ZDA>RMC
RMC>RMA>VTG>VHW
TTM
MWV>VWT/VWR
HDT>HDG>HDM>VHW
HDM>HDG>HDT>VHW
RMC>RMA>VTG
DPT>DBT>DBS>DBK
RMB>WPL>BWR>BWC
MTW
TLL (output from VHF radiotelephone FM-2721)
DSC>DSE (output from VHF marine transceiver FM-3000)
2-2
Vinyl tape
DATA3 (6P)
External buzzer,
PC, NMEA IN (Echo
sounder)
DATA4 (7P)