Furuno 1824C Installation Manual page 29

Mounting the antenna unit
The antenna unit can be mounted using the fixing holes on the outside (200 x 200 mm) or
inside (140 x 150 mm) the antenna unit.
Using outside fixing holes of the antenna housing
Use the hex head bolts (supplied) to mount the antenna unit as below.
1. Lay the corrosion-proof rubber mat (supplied) on the mounting platform.
2. Lay the antenna unit on the mounting platform, orienting it as shown in below.
STERN
Bow mark
Location of rubber mat
Antenna unit
CAUTION
Do not lift the Antenna unit by the
radiator; lift it by the housing.
The radiator may be damaged.
1-19
Ground
terminal
Rubber
mat
BOW