Replacing The Razor Heads - Philips Norelco AT811 User Manual

ENGLISH
20
C
7 Clean the inside and outside of the comb
with the brush supplied.
For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
(e.g. Philips Norelco Shaving Head Cleaning Spray,
Model HQ110 or alcohol) and lubricated with
one drop of mineral oil (in the center of the
head). This helps prevent wear of the shaving
heads.
C
8 Replace the set back into the Razor Head
Assembly.
Make sure that the two pointy edges of the
head fit exactly into the recesses.
9 Repeat the process for the other two sets
of cutters and combs.
10 Replace the frame and turn the lock
clockwise until it locks into place.
C
11 Insert the notch of the shaving unit into
the slot in the top of the razor (1) and
1
2 then close the shaving unit (2).
NOTE: If the shaving unit does not close smoothly,
make sure you inserted the shaving heads
properly and that the retaining frame is locked.
Put the Protective Cap on razor to protect
12
heads.
After Each Use: Trimmer
1 Turn razor OFF.
C
2 Push down spring-release trimmer switch.
C
3 Clean trimmer with the short-bristled side
of the brush every time you use it. Brush
up and down along the trimmer teeth.
C
4 Lubricate the trimmer teeth with one
drop of mineral oil every 6 months.
5 Close trimmer by pressing trimmer down.

Replacing the Razor Heads

w Replace the razor heads once a year for
optimal shaving results.
w Replace damaged or worn razor heads with
model HQ8 Philips Norelco razor heads only.
ENGLISH
21