Table of Contents
Advertisement
L540E CERAMIC BURNER REMOVAL / INSTALLATION
REMOVAL
1) Remove left and right side panels by sliding them forward - see below.
2) Lift the Burner slightly while pulling forward to clear the mixing tube.
3) To install - reverse Steps 2 and 1.
L540E-2 / HZI540E-2 Direct Vent Gas Insert
INSTALLATION
Care must be taken when installing the burner into the firebox.
Do not damage, knock or scrape the pilot assembly.
The flame sensor and ignition lead are fragile and can be damaged
*Satin black paint is included if touch ups are required.
Pilot Assembly
Burner Mounting
Bracket left
Gas Orifice
Burner Locking
Tab
Important Note:
A correctly installed burner - the burner is back far enough,
lower the front edge so that the front flange of the burner
(underneath) sits down into the grooves in the burner mount-
ing brackets Left and Right. There will be a small gap between
the Ceramic Burner and the firebox Bottom Flange. The Burner
should be situated about ¼" (6mm) inside the front edge of the
firebox.
6mm
MAINTENANCE
easily.
Burner Mounting
Bracket right
Air Shutter
Mixing Tube support
45
Hide quick links:
Advertisement
Table of Contents
