Step2: Enter Wheel Circumference - Oregon Scientific OUTBREAKER RS109 User Manual

To attach the equipment:
1. Select from one of two bike ring sizes -- 2.4-2.6 or 3.0-3.2 cm
in diameter (0.95-1.02 or 1.18-1.26 inches in diameter) --
appropriate for your bike handle bar. Then slide the bike ring and
secure it into slot located at the bottom of the bike mount.
2. Attach the bike mount to the right or left handlebar using rubber
grip, nut and bolt provided. Tighten until the bike mount is fixed
into place, using the rubber grip for a firmer contact.
3. Attach the cadence sensor to a stationary point just behind
the pedal, using the rubber grip for a firmer contact. There
should be maximum 100cm (39 inches) between the sensor
and the bike mount, and less than 30 degrees vertical angle.
4. Attach the cadence magnet to a pedal so that it is directly aligned
with the sensor with less than 5mm (0.2 inches) between.
5. Attach the speed sensor to either leg of the front forks, using
the rubber grip for a firmer contact.
maximum 100cm (39 inches) between the sensor and the
bike mount, and less than 30 degrees vertical angle.
6. Attach the speed magnet on a spoke of the front wheel so
that it less than 5mm (0.2 inches) from the sensor.
7. Check and adjust as necessary, then snip the ends off the
clips so that no excess remains.
8. Fit the watch into the bike mount.
9. Press MODE on the watch to switch to BIKE Mode.
10.Press ST/SP/- to activate signal reception. The display shows "-
-", then changes to 0 once a successful signal is received.
11.Ride the bike a short distance to make sure signals are being
sent to the watch successfully.
12.You are now ready to begin your trip.
NOTE
NOTE
'Battery' section) replace the battery for the corresponding unit.
STEP 2: ENTER WHEEL CIRCUMFERENCE
You must set the bike's wheel
circumference on the watch so it can
accurately calculate your speed and
distance. If you do not know the bike's
wheel circumference, you can check the
manufacturer's specifications or measure
it by marking the wheel where it touches
the ground, and then rotating the wheel once fully along the
ground. Measure the difference between the two marks.
NOTE
There should be
To specify this information on the watch:
1. Press MODE to switch to the BIKE Mode.
2. Press and hold FUNC/SET for 2 seconds.
3. Press SELECT/+ or ST/SP/- to change the circumference
(cm or inches, depending on the measurement unit you
selected in CLOCK Mode).
4. Press FUNC/SET to save your changes.
NOTE
PC section).
21
The watch can work with one or both sensors.
When the display shows a low battery icon
Most wheels have their specifications written on them.
You can also use the PC software for this operation (see
(see