Mazda 6 Manual page 22

Essential Safety Equipment
Seats
2. After unlocking the doors, the seat
position adjustment begins within 40
seconds of opening the driver's door,
and a beep sounds when the operation
is finished.
NOTE
If there is no seat position movement, a
l
beep is not heard.
When the ignition is switched ON, the seat
l
position memory function does not operate
unless the selector lever is in the P position
(Automatic transaxle) or the parking brake
is applied (Manual transaxle).
When the ignition is switched OFF, the seat
l
position memory function is operable while
the selector lever is in a position other than
P position (Automatic transaxle) or the
parking brake is not applied (Manual
transaxle), however, if the ignition is
switched ON while the seat position
memory function is operating, the operation
is stopped.
The seat position adjustment is canceled in
l
the following cases:
Any of the seat adjustment switches is
l
operated.
The SET button is pressed.
l
Programming button 1 or 2 is pressed.
l
The key switch or
l
operated.
The vehicle starts moving.
l
Erasing programmed seat positions
(Erasing the seat positions programmed
to the key)
1. Switch the ignition OFF.
2. Press the SET button on the seat until a
beep sound is heard one time.
3. After the beep sounds, press the key
switch within 5 seconds until a beep
sound is heard one time.
2-10
switch is
NOTE
If a beep sound is heard three times, the
operation is canceled.