Starting Wps Registration And Configuring Wps - Gigaset SX763 Manual

transfer rates in your network. To operate clients with older wireless network adapters
in your network, select IEEE 802.11b/g (mixed).
ì
Select the required transmission mode for your wireless network.
Sending power
ì
Select the required sending power for your device.
It is recommended that you select a sending power with a range to suit the spatial
environment of your local network. A much greater range makes it easier to eaves-
drop on your wireless data transfer.
Super G (108 Mbit/s)
With the help of channel bundling, the
data transfer up to 108 Mbps. The channel for wireless data transfer cannot be changed.
You can only use Super G if this function is supported by at least one client in your wire-
less network. For the best possible data transfer rates, all clients in your LAN should sup-
port Super G.
Please remember:
If you activate Super G as the transmission mode, but it is not supported by all
components in your wireless network, then for technical reasons the transfer rate in
the network may be significantly lower than the possible maximum of 108 Mbit/s.
ì
Select Dynamic to use Super G (108 Mbit/s) for your wireless network to increase
the data transfer rate. Dynamic means that the router will accept participants which
communicate via different transmission rates, and will adapt to the slowest client in
the network.
In the default setting, Super G (108 Mbit/s) is activated.
ì
Click OK to apply the settings.

Starting WPS registration and configuring WPS

Wi-Fi Protected Setup (WPS) makes it easier to establish a wireless network. Devices
equipped with WPS can synchronise the SSID and the WPA key (pre-shared key).
The most simple method to establish a secure wireless connection is press the registra-
tion (Scan) button or click once in the user interface of the Gigaset SX763 WLAN dsl and
do the same with the client. For further information, see "WPS" on page 15.
The configuration program of the Gigaset SX763 WLAN dsl provides beside the Push
Button method for WPS registration for more security the registrations mode via PIN.
ì
In the Advanced Settings menu select: Wireless Network – WPS Registration
Configuring Advanced Settings
Super G transmission mode enables wireless
85