Fujitsu Primergy RX100 S3 User Manual page 32

Chapter 1 Overview
1
Open the rack door.
2
Make sure that the CD-ROM drives are empty.
3
Press the power switch of the monitor and peripheral devices.
4
Press the power switch on the front of the server.
The server's power LED turns green. When the power is turned on, the server performs "POST
(Power On Self Test)" which checks the device of the server. If any abnormalities are detected by
POST, error messages appear.
"9.2.2 Error Messages" (pg.240)
The time to turn off the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView supplied with this server. For details, refer to "3.2 Settings for Server Monitoring" in
"ServerView User's Guide" on the PRIMERGY Document & Tool CD.
If you press the [F8] key right after the POST memory amount check, the Boot Menu is displayed,
where you can change the boot disk ( "
32
The server's
Power switch
power LED
turns green
■
How to Start the BIOS Setup Utility" (pg.202)).