Fujitsu Primergy RX100 S3 User Manual page 251

■ Fails in Remote Installation
If remote installation fails, check the following.
●
Checking Services
Check that the DHCP, PXE Service, and TFTP Service are running.
For checking procedures, refer to "3.4 Remote Installation" ( pg.86).
●
Setting TFTP
To access TFTP Service, add a Guest account to the TFTP folder and set appropriate access rights.
For setting procedures, refer to "3.4 Remote Installation" ( pg.86).
●
Checking Network Function Settings
The server must support network startup (PXE).
For the setting procedures, refer to "
Settings" ( pg.41).
●
Checking the MAC Address
Check that the current MAC address is the correct MAC address of the server.
For the MAC address checking procedures, refer to "
"2.1.2 Hardware Settings" ( pg.41).
●
Checking LAN Cable Connection
Check that the LAN cable is connected to the LAN card corresponding to the specified MAC address
and that the LAN card is connected to the network.
■ An Error Occurs during Backup on Windows Server 2003
The following error messages may appear during backup by the OS's standard backup software on
Windows Server 2003.
The device reported an error on a request to write
data to media.
Error reported: Invalid command.
There may be a hardware or media problem.
Please check the system event log for relevant fail-
ures.
This error message may appear if you specify an onboard SCSI device as the destination of the backup
file and if you make a backup copy using the OS's standard backup software on Windows Server 2003.
If the message is displayed, get the Service Pack 1 or Hotfix (817688) from website of Microsoft, and
apply one of them.
●
Performing Remote Installation" ( pg.41) in "2.1.2 Hardware
●
Performing Remote Installation" ( pg.41) in
PRIMERGY RX100 S3 User's Guide
9
251