Leakage Protection Special Plug Instruction; Control Panel - Ariston HW65/9H Instruction Manual

Note: Before turning on the power switch, make sure the product is kept standby for at least 30
minutes, the tank is completely filled with water and the whole system is free from leakage.

5.2 Leakage Protection Special Plug Instruction

Make sure the tank is completely filled with water and the system is free from leakage, and then put
the leakage protection special plug into the outlet:
5.2.1 Press "Reset" button and "Safety Guardian" indicator lights up; then press "Leakage
Inspection" button to turn off the power and "Safety Guardian" indicator dies out; and again, press
"Reset" button and "Safety Guardian" indicator lights up, now the product is ready for operation.
5.2.2 If it's not reset after pressing "Reset" button and "Safety Guardian" indicator does not light up,
then you should contact Ariston customer service to run system inspection; if the product is not
correctly grounded then "Incorrect Grounding Protection" indicator will light up and keep active
until being disconnected. Then leakage protection function is activated to cut the power and
extinguish "Safety Guardian" indicator. Now, you should stop using this product, remove the plug or
disconnect any power supply and contact manufacture's maintenance staff to resolve any possible
malfunction.
5.2.3 User should regularly inspect the product following the process of 5.2.1. If leakage protection
special plug accidentally cuts off the power when the product is running, please perform the test
following the process of 5.2.1 and continue to use the product if no problem is found.

6. Control Panel