Ariston HW65/9H Instruction Manual page 10

B. How to install this product with L-shaped installation component
·To drill the holes with kirner that is smaller than expansion pipe and then apply to aiguilles with
the same diameter as the expansion pipe to adjust the pre-drilled holes to suitable size in a non-
impact way.
·Insert the expansion pipe and screw L-shaped hook into it using a wrench or other suitable tool
until the distance of the hook head from the wall is "A" (figure g) with the head being upward.
(Refer to the following figure to learn distance "A").
Model
HW65/9H
HW80/9H
·Lean the product close to the wall and slowly move it downward until the hook is attached to
installation bracket and then pull it down to make sure the product is fastened.
C. If the floated coat of the wall is too thick or the wall is consist of hollow bricks, then it is
necessary to install additional supporting bracket to make sure the product is well fastened.
D. Installation Distance
Installation Distance: 384mm for HM65/9H and 467mm for HW80/9H
A
There's two ring marks at the tail of L-
shaped installation component. Refer to
the following figure to learn the exposure
length. Wall should be at the between of
two rings.