Sony MHC-GT5D Operating Instructions Manual page 21

Installing the speaker units as
a combined unit (Soundbar
style) on a wall
Notes
Use screws that are suitable for the
• •
wall material and strength. As a plaster
board wall is especially fragile, attach
the screws securely to a wall stud. Install
the speaker system on a vertical and flat
reinforced area of the wall.
Be sure to subcontract the installation
• •
to Sony dealers or licensed contractors
and pay special attention to safety
during the installation.
Sony is not responsible for accidents
• •
or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1
Combine the speaker units
(Soundbar style) (page 20).
2
Prepare screws (not supplied)
that are suitable for the holes
on the back of the speaker
system.
More than 25 mm
Hole on the back of
the speaker system
5 mm
10 mm
3
4
4 mm
Drive the screws to the wall.
The screws should protrude 6 mm
to 7 mm from the wall.
6 mm to 7 mm
Hang the speaker system onto
the screws.
Align the holes on the back of the
speaker system to the screws, then
hang the speaker system onto the 2
screws.
Note
Be sure to hold both the speaker units.
The combined speaker units may
come off if you only hold one end.
387 mm
21
GB