Pairing A Bluetooth Device - Denon Envoi User Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Operation

Wireless Mic Setup

To use the included wireless mic, follow these setup steps:

Ensure 2 new AA alkaline batteries are installed in the wireless mic (see the battery

installation side graphic). The microphone handle unscrews to reveal the battery

compartment. Screw the handle back on with the threads facing inward.

On the UHF Receiver panel on Envoi, turn on Power-Vol knob clockwise.

Turn on the wireless microphone using the switch found on the bottom of the

microphone. Watch the AF indicator to make sure a signal is being received.

Use the Up or Down buttons to select a wireless channel that gives a strong signal.

Hold the microphone close to your mouth when speaking and the AF LED will

illuminate on the Wireless Mic Settings panel. Adjust the Power-Volume knob to

increase the level.

Note: If needed, the High/Low (H/L) switch on the wireless mic (see the side

graphic) can be adjusted to increase the signal range. The High power setting

consumes more battery power to provide extended range and reception. The Low

setting extends battery life for use in scenarios where a lower operating range is

acceptable.

Note: If needed, the gain adjustment on the microphone can be adjusted clockwise

for more output gain. For less output gain, the screw can be adjusted counter-

clockwise.

Mute Level

In most situations this should be left at the factory preset position. However, in cases of

high RF activity, the mute levels can be re-adjusted to suppress interference from other

wireless devices in a shared RF environment. This will reduce interference when an audio

signal is not present. If the AF or RF LEDs flicker or stay on when the wireless

microphone is off, the Mute Level screw on the UHF receiver panel should be turned

counter-clockwise until the LEDs are off. When the Mute Level is properly adjusted, the

corresponding AF and RF LEDs will light up only when the wireless microphone is being

used.

Setting ASC (Auto-Sync Channel)

If you receive interference or if another channel is needed, select another channel using

the ASC (Auto-Sync Channel) button.

Select the UHF channel you want to use with the best reception using the Up or

Down buttons.

Turn the microphone on and place the microphone's sensor (found above the

battery compartment, seen in the graphic above) near Envoi's IR LED.

Press the ASC button once on Envoi and wait for about 3 seconds, until the IR

LED stops flashing. When it finds an interference-free channel, the wireless mic will

be matched to that channel.