Main Unit - Rear Panel - Datavideo SE-2800 Instruction Manual

DIGITAL VIDEO SWITCHER
AUDIO OUT
CH1
AUDIO IN
CH1 CH2
TALL Y OUT
GPI
RS-422 REMOTE
DC IN
12 V 48W

Main Unit - Rear Panel

POWER
The front panel on the SE-2800 main unit has a grille for two airflow cooling fans. Please do not block
or cover this grille as the unit may overheat. This grille should also be kept free of dust. The front panel
can be removed by using the four thumbscrews. A soft brush or cloth can then be used to clean the
grille before attaching it back to the unit.
The power button starts and shuts down both the SE-2800 main unit and its attached keyboard.
10
AUDIO OUT
Supports two channels XLR Balanced Audio output.
CH2
See page 29 for more details.
AUDIO IN
Supports four channels XLR Balanced Audio Input.
CH3 CH4
See page 29 for more details.
TALLY OUT
The SE-2800 Tally Output port provides bi-colour tally
information to a number of other Datavideo products, such as
the ITC-100 eight channel talkback system or the Datavideo
TLM range of monitors. See page 34 for more details.
GPI
The GPI socket can be used for simple external control.
See page 33 for more details.
RS-422 REMOTE
This feature is not currently active. A firmware update may
be released at a later date. Please check with your local
Datavideo office for advice on this connection and the latest
firmware.
DC IN
Connect the supplied 12V 5A PSU to this 4pin XLR socket.
4 1
3 2
Pin 1 = GND ( - )
Pin 2 = NC
Pin 3 = NC
Pin 4 = VCC ( + )
Grounding Terminal
When connecting this unit to any other component, make sure
that it is properly grounded by connecting this terminal to an
appropriate point. When connecting, use the socket and be
sure to use wire with a cross-sectional area of at least 1.0 mm.
SE-2800 DIGITAL VIDEO SWITCHER