Procedure 7.1 - Replacing Or Removing A Rear Cover Section - Precor EFX 5.17i Service Manual

Procedure 7.1 - Replacing or Removing a Rear Cover Section

Warning: Care must be taken when work is being performed in the area of the stairarms. Pinch
points exist between the stairarm and ramp and between the stairarm and crankarm,
when the rear covers are removed.
Procedure
1. Set the on/off switch in the "off" position, then unplug the power cord from the A.C. outlet.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. The rear cover is a five piece cover; upper and lower front, top, left and right sections.
3. If you are removing either the right or left cover section, it is only necessary to remove the
four screws that fasten the cover section.
4. If you are replacing either the front or top cover section, you must first remove the left and
right cover sections and then remove the cover section being replaced.
5. If you are removing the top cover (See Diagram 7.1), remove the two phillip screws that
fasten the top cover section to the frame upright. Remove three screws that fasten the top
cover section to the rear cover support. Remove two screws that fasten the top cover
section to the front cover section.
6. If you are removing the upper front cover section, the right, left and top cover sections must
be removed first. Remove two phillips screws that fasten the bottom of the front cover
section to the frame. The lower front cover section is fastened to the frame by two screws
(See Diagram 7.2).
Diagram 7.1 - Top Cover Section (with right & left cover sections removed)
Top Cover
Section
Front Cover
Section
5.17i Ellipitical Fitness Crosstrainer
Mounting
Screw
Frame
Upright
Page 34