Singer XL-580 Instruction Manual page 100

Multi-hooping is a special feature in the software that will allow
embroidery data which is larger than a single embroidery hoop
to be sent to the machine to stitch out, while making it easy to
rehoop the fabric so that each part of the design lines up exactly.
This embroidery data may be a single design that is too large for
the hoop or a combination of smaller embroidery elements and/
or lettering, that when combined together make a much larger
different parts; and then sews them precisely, matching one
section to the other. When re-hooping the fabric, the Multi-
hoop feature will compensate for misalignment if the fabric has
been placed slightly askew in the hoop.
When stitching an embroidery design that is too large for the
fabric. When these points are input, they inform the machine
exactly as to how the fabric is positioned into the hoop and will
therefore sew the design to the alignment of the cross lines. If
the fabric is slightly askew, this system will compensate for it and
compensate for a slight misalignment in the vertical cross line.
Please try to hoop the fabric as accurately as possible.
P l e a s e n o t e : T h e f a b r i c m u s t b e l a r g e e n o u g h t o
accommodate the amount of hoops that will be required to
stitch out the design.
1. Using a very
vertically down the center of the fabric.
2. Mark a line horizontally across the center of the fabric.
The vertical and horizontal lines must be at precise right
angles to each other. These lines will now be referred to
the fabric into the hoop according to the divided design
layout.
Tools from the horizontal tool bar, select
and then select
the upper left corner.
94
.
Fig. 1
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 2
Intersection of cross
lines must be at perfect
90 degree angles.
L'intersection de lignes
líneas de cruce deben
e s t a r e n á n g u l o s
perfectos de 90 grados
#1 in
L O V E
Fabric
Tissus
Tela
broderie.
Cross line
Ligne de
Línea de
cruce
Cross line
Ligne de
Línea de
cruce