Park Position - Singer XL-580 Instruction Manual

TM
There are many different types of images or formats of
using vector type images, such as .wmf. The software
impractical for use.
but it may lose detail, depending on the image. It is
essential to understand about the type of artwork or
saved when scanning. The computer sees millions of
3-color design that we see as simple has billions of
pixels. Common formats recognized by the software:
.bmp, .jpg, .tif, .pcx, .pcd, .tga, and .psd.
Lines that are too narrow to properly sew out are
eliminated by the software when it cleans up the artwork.

11. Park position

If you need to change the bobbin thread while embroidering
a design with the Endless hoop, it may be necessary in
The Endless hoop has a clamp at the back that can
possibly interfere with the removal of the hoop from the
embroidery unit, depending on the size of the design being
embroidered. By moving the hoop to a Park position, the
needle moves to center position temporarily, allowing you
to remove the hoop from the embroidery unit, change the
bobbin thread, reattach the hoop and then move back to the
original position where you stopped the embroidery design
so that you can resume stitching.
position and stopped when using the Park position
function.
Press the Twin needle button after the embroidery unit
The needle will move to center position. You
can now remove the hoop from the machine and
change the bobbin thread.
When the needle is in the Park position, the Twin
will blink red.
the embroidery unit. Press the Twin needle button once
again so the needle moves back to the original position
where you stopped embroidering. To resume embroidery,
button.
92
Vector Art / Vector Art (mode vectoriel) / Vector Art
Bitmapped Art / Bitmapped Art (mode point) / Bitmapped Art