Cable Diagram; Assembly - Weider 8510 User Manual

CABLE DIAGRAM

The cable diagram below shows the proper routing of the Short Cable (58) and the Long Cable (23). Use the
diagram to be sure that the two cables and the cable traps have been assembled correctly. If the cables have
not been correctly routed, the home gym system will not function properly and damage may occur. The numbers
show the correct route for each cable. The starting and ending points of each cable are labelled. Be sure that
the cable traps do not touch or bind the cables.
2
7
5
6
5—Long "U"-Bracket
Weight Stack—8
1—High Pulley
3
4
TOP VIEW
Long Cable (23)
Short Cable (58)
4
3
1—Low Pulley
2
20

ASSEMBLY

Before beginning assembly, carefully read the
following information and instructions:
• Place all parts of the home gym system in a
cleared area and remove the packing materials;
do not dispose of the packing materials until
assembly is completed.
• The assembly is divided into four stages: 1)
frame assembly, 2) press and butterfly arm
assembly, 3) cable and pulley assembly, and 4)
seat and backrest assembly. The hardware for
each stage is packaged separately.
• Wait until you begin each assembly stage to open
that parts bag.
• For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART located in the centre of this manual.
Note: Some small parts may have been pre-
attached for shipping. If a part is not in the parts
bag, check to see if it has been pre-attached.
1. Before beginning assembly, be sure that
you have read and understand the infor-
mation in the box above.
Press a 2" Square Outer Cap (51) onto each
end of the Stabiliser (5). Press a 2" Square
Inner Cap (27) into the end of the Base (4).
Insert two 5/16" x 2 3/4" Carriage Bolts (14)
up through the Stabiliser (5). Insert two 5/16"
x 2 1/2" Carriage Bolts (1) up through the
Base (4).
Slide the indicated end of the Base (4) onto
the 5/16" x 2 3/4" Carriage Bolts (14) in the
Stabiliser (5). Slide the Rear Upright (56)
onto the Carriage Bolts. Hand tighten a 5/16"
Nylon Locknut (3) onto each Carriage Bolt.
The high side of the bracket on the Rear
Upright must be on the side shown. Do
not tighten the Nylon Locknuts yet.
• As you assemble the home gym system, be sure
that all parts are oriented as shown in the
drawings.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable spanners
• One (1) standard screwdriver
• One (1) phillips screwdriver
• One (1) rubber mallet
• Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end spanners, or a set of ratchet spanners.
1
High Side of
Bracket
56
3
51
5
4
51
14
1
5
27